Mechanic and Hydraulic, Plumbing

LOCTITE ANTI-SEIZE MARINE

MARINE GRADE

Anti-seize paste with brush applicator tip, black, metal free, made with graphite, calcium, boron nitride and corrosion inhibitors. ABS approved.

LOCTITE® LB 8023 is a black, metal-free, brush-tip anti-splitting lubricant paste made with graphite u, calcium, boron nitride and corrosion inhibitors. ABS approved, it protects components from fresh and salt water.

Used in high humidity conditions. It has excellent lubricity, good resistance to water wash-out spray and prevents galvanic corrosion. High temperature resistance up to 1315°C.
Metal free
ABS approved
High temperature resistance up to +1315°C
Excellent lubricity, excellent resistance to water splashes
Protects against galvanic corrosion
Designed to be suitable for high humidity conditions, and to resist fresh or salt water

PRODUCT PERFORMANCE

An anti-seize lubricant used on bolts allows
to obtain a higher tightening load for the same torque
torque compared to a non-lubricated bolt. Another benefit is
benefit is a greater uniformity of clamping load in a series of
load in a series of bolts. The relationship between torque
and load is expressed by the following formula:

T = K x F x D
T = Torque (N-m, lb.in, lb.ft)
K = Eigenvalue of the thread, determined experimentally
determined experimentally
F = Tightening load (N, lb.)
D = Nominal screw diameter (mm, in.)

GENERAL INFORMATION

The use of this product is not recommended in installations
oxygen or oxygen-rich mixtures, it should not be used in installations
oxygen-rich mixtures, it should not be used as a lubricant in the presence of
lubricant in the presence of chlorine or other strongly
oxidizing compounds.
For information on the safe use of this product, consult
of this product, it is mandatory to consult the
Safety Data Sheet (SDS).

Recommendations for use

1. To obtain the best performance, the interfaces
must be clean and free of grease.
2. Clean parts with a wire brush prior to application.
application of the product.
3. Coat the surfaces to be treated, assemble them.
4. Do not dilute products with solvents.
5. Keep container closed after use.